|
IF YOU LIKE,
and use any of my projects or libraries, and would like to encourage further development you can donate through PayPal here:
Rather donate hardware directly? Then click here.
|
|
|
|
|
|
URTouch Calibration Data Verification
|
|
Displaytype | : | ITead Studio - ITDB02-2.8 V2 | Your CAL_X | : | 0x004F0ED2UL | Your CAL_Y | : | 0x0037CEBAUL | Your CAL_S | : | 0x000EF18FUL | |
Results: | • Orientation is correct... | • Display size parameters are not correct... | • CAL_X data sequence is not correct... | • CAL_Y data sequence is not correct... | |
Suggestions: | • | Your display size parameters are incorrect. This is most likely caused by a typo. Please recheck your CAL_S data. | | • | Your CAL_X data seems to have switched left and right. This should not happen on a supported display module. Are you sure you are using a display module on the list of supported modules (See the "URTouch_Supported_display_modules.pdf" document supplied with URTouch)? You can try running the calibration again but I do not think it will help. | | • | Your CAL_Y data seems to have switched top and bottom. This should not happen on a supported display module. Are you sure you are using a display module on the list of supported modules (See the "URTouch_Supported_display_modules.pdf" document supplied with URTouch)? You can try running the calibration again but I do not think it will help. | | | |
|
|